Auto Electrics Bolton

Electrical Components Replaced Bolton
Alternators, starter motors, relays, wiper motors and most electrical components supplied and fitted Bolton
Bolton Fault code reading and diagnostics
Electrical faults investigated and repaired in the Bolton area
Sensors
Electronically controlled sensors for air flow, temperature and oxygen tested and replaced

Replacement Alternators Bolton

Belt Drive
Most alternators are belt driven from the engine and require minimal maintenance other than changing the drive belt at the appropriate service interval
Starter Motor Bolton
When the ignition system is initiated; an electrical signal switches a relay-solenoid to send power to the starter motor - The starter motor then engages the drive gear to turn and start your engine
Power Train Control Module (PCM) & Electronic Control Unit
The engine management system will take control of regulating the output voltage from the alternator by switching the field current on and off with millisecond precision
Relays Bolton
Relays are electric switches that typically use a small current or voltage in one circuit to close a switch that allows a much larger current to flow in a second circuit
Battery Warning Light
Once your car has been started; if the battery warning light remains on then there could be a problem with the alternator-charging system or the battery itself
Bolton Alternator Repairs
Alternators generate an alternating curent (AC) rather than the direct current (DC) used by automotive electrical systems; in order to convert AC to DC an array of diodes and rectifiers take the negative part of the voltge and invert it: A voltage regulator then maintains the 13 to 15 Volt power ouput needed to charge the battery nd run the autoelectrical systems
Car Won't Start
Most ignition problems are caused by battery failure or poor connection: Other causes include starter motor,fuse or relay failure

Engine Won't Turn Over

• Faulty ignition switch
• Engine seized
• Poor electrical Contact
• Dead or Flat Battery

Engine Turns Over but Won't Start

• Immobiliser faulty
• Fuel Pump broken
• Fuel pump relay faulty
• Blown fuel pump fuse
• No Fuel
• ECM or PCM fuse blown or shorted

Fuses Relays and Connections

Blown Fuse
When parts of the electrical system fail then often the problem can be traced to a blown fuse or relay
Corroded Joints
Corroded joints can lead to connection problems and may be caused by water ingress or a mechanically loose joint sparking and oxidising

Electrical Testing and Installation Bolton

Bolton Starter Motors
Replacement Bolton Starter motors installed
Bolton Electrical Components
Electrical faults repaired using OEM components - Critical sensors checked e.g. Lambda sensors, air flow meters etc
Bolton Performance Spares Fitted
OEM replacement parts fitted or upgraded with alternative performance parts such as suspension kits and air filters
Bolton Fuel Pumps
Often replaced at a milestone service if the fuel pump is operated by the Timing belt
Bolton Engine Servicing & Repair
Engine repairs, cylinder head skimming, valves & pistons replaced Bolton
Bolton Autoelectrics - OBD & OBD II
Bolton electrical faults diagnosed - OBD fault finding - engine fault codes checked & service lights reset - ECU problems diagnosed, key re-coding and CANBUS systems checked
Bolton Cooling System
Replacement Bolton radiators fitted, cooling system pipework inspected for leaks and cooling fluid replaced to keep your Bolton engine at its optimal operating temperature
Bolton Alternators
Replacement Bolton alternators fitted